ThermaltronicsTMT-TC-2 Lead Free Tip Tinner (20g)

Oh dear, what an awful headline. Fortunately, the tip tinner is not awful. I've got tinner from another brand, and somehow this one is significantly better. It coats more quickly and easily, and since using it I've had absolutely no problems with degradation of my solder tips.At the end of soldering, wipe off the solder from the tip and then gently put the tip into the tinner. It's like sand, but it melts on contact. Rotate the soldering iron and you've got full coverage. Simple. If there are areas where the tinner won't stick, those will need a bit of sanding.I didn't use to bother with tinner that much, and just went with some excess solder at the end of a soldering session. Predictably that didn't work out perfectly for me. The tin of tinner seems to basically last forever, so it's way cheaper than extra iron tips. Would strongly recommend, everyone should have a tin... of tinner.

does as it says on the tin, helps a lot when soldering . good item.

This works great for maintaining the top of my Hakko soldering iron, which I use multiple times per week for stained glass at around 360/410 degrees using blowpipe solder and liquid flux. I tin the tip probably four or five times a ‘session’ and before I switch the iron off. Lasts for ages even though it’s only a small tin. Only isdue I’ve had is as it’s a tin with a sort of press fit seal, if the tin starts to corrode/rust it jams and us an absolute nightmare to prize open again!Great value though - almost half the price of the stained glass specialist suppliers I use for the rest of my kit online.

Purchased this to help with a new soldering iron I was having trouble with. Just heat your soldering iron up and place the tip in the tip tinner, some of the stuff in the tin melts around the tip, give it a wipe on your wet sponge etc. and your done, perfect tinned tip.

Excellent at revitalising soldering iron tips. Works well. A small application of the tinner gives good results.

Novice solderer here.I got this to re-tin my soldering iron(s) tips. The first photo is of a temperature-controlled soldering station which I haven't been using for long.The second is my main iron and first love, which was badly oxided. I tried re-tinning for 30 mins and this was the best I got.The substance/product is great but the tip was too oxided(never been tinned or taken care of properly). Anyway, as you can see from the second photo, the tip is partially tinned but it conducts heat properly now and solder flows well.Learning from the first re-tinning, I immersed the other in vinegar and after about 2 hours, the oxides were "corroded" away. Thinning in the product was a breeze. The adhesion was a lot better with a cleaner and less oxided tip.This would help me take better care of my soldering tips. The amount/size in the tin is adequate for several jobs. Well worth the money paid.I would recommend it to every novice and experts.

I am a terrible solderer and constantly burn the tinning off my irons while I'm flailing about trying to get a good joint. So believe me when I say that this is a life-saver. I tap the tip into this mixture of solder and flux and voila - instantly clean, tinned iron..... which I ruin in a matter of seconds.... then back to re-re-tin. In conjunction with a tip cleaner (brass swarf in a tin, also for sale on Amazon) and a pot of flux I can now solder lake an amateur - instead of my usual 'rank' Amateur status.Give it a go, it's cheaper than buying bits for most irons.

not that good