XFasten Double Sided Woodworking Tape w/Yellow Backing 2.5 Inches x 30 Yards

I use this for my CNC machine. It is so sticky and it works so good for holding my project on the bed. I have no worries of it coming loose. I literally cut five pieces 2 inches long place two in each corner at the end one in the center and I have not had anything come loose. Excellent product thickness is great. Very minimal values. Good ease of use. Oh yeah.

This is great stuff!! Extremely sticky!! Works great for clamping wood material together or down to a waste board. Easy to remove and leaves ZERO residue!! I've used on MDF, oak, walnut, pine, poplar and works great on all of them. Actually had to resort one time to using a putty knife to pry to pieces apart!!I highly recommend this product!

GREAT PRODUCT, QUICK DELIVERY!

I decided to upgrade my review after using the carpet tape (white) version of this tape. Both my X-fastenFor CNC work this tape is very easy to apply, and the initial grab is not super aggressive. The white version of this was much more aggressive. I'm not sure if it's the backing or the tape or both, but this version is thicker than the white version, so this makes it very easy to apply without a tendency to wrinkle. Anyone who's doing CNC work and has critical depth cuts to make or engraving knows the importance of maintaining an even thickness. This tape really excels here, as it's more idiot proof than the white stuff or thinner versions of tape. Under normal use it removes very easily with no residue.Let's talk a situation you're likely to encounter though. As a router bit spinning at 12,000+ RPMs hits this it has a tendency to melt. Not only does this gum up bits, it makes the areas where you've routed difficult to get the tape off of. I've even coated my CNC table with some polyurethane to improve adhesion, but this stuff can still be a bugger to get off of your waste board. Some isopropyl alcohol helps.Overall, I think it works excellent for CNC work, but this bear in mind it's going to be a bit tedious to do the final clean up.And here's another tip for people doing CNC work and there's plenty of videos out there that demonstrate the technique. Get yourself some of the blue painters tape, and some medium thickness crazy glue (cyanoacrylic) glue. Apply the glue to one surface of the painters tape, and spray the mating side with accelerator. Upon contact the bond is instant. Only drawback is you don't want to get the glue beyond the edge of the tape, and two, I'm not so sure the accelerator is the greatest thing for your lungs. This does not leave any residue behind, and is easy to remove. Overall I think it's a little more expensive than double stick tape, but it works exceptionally well, and I've even seen guys machine aluminum with this technique.For general purpose CNC work, I'll be buying more of this double stick tape, as overall I find it much easier to apply and don't have to worry about alignment of the painters tape and crazy glue technique.Good product and so far does not leave any residue on the actual work, although be aware as it gets hot it does melt and makes cleanup more difficult on your waste board.

Great for covering holes in wood so the epoxy doesn't go through, very sticky.

Excellent multipurpose 2 sided tape. Holds very well, but can be removed without leaving any glue behind. Highly recomment.

Good product

Holds well and paper is easy to remove. It’s my go to double-sided tape.